*1 Visit for the latest information about the recommended batteries. Tape cassette: Brother P-touch TZe tape widths: 3.5 mm, 6 mm, 9 mm, 12 mm Brother HGe tape widths: 6 mm, 9 mm, 12 mm Power supply: Six AAA alkaline batteries (LR03) Six AAA Ni-MH batteries (HR03) *1 Optional AC Adapter (AD-24ESA) 400 g (without batteries and tape cassette) Specificationsĭimensions: (W x D x H) Approx. WARNING Do not touch the cutter blade directly with your fingers. Push it in gently until it locks into place. Remove the two sections of the Cutter Unit (green) in the direction of the arrows as illustrated below 2.TC-4) from an authorized Brother reseller. If you still have difficulties, replace with a new cutter unit (stock no. If the cutter blade becomes blunt after repetitive use and the tape cannot be cut cleanly, rotate the cutter board as shown in the illustration 1. To return to the default setting, press the Space key.There are five levels from (darkest) to (brightest). The P-touch labeling system automatically turns off if it is inactive for five minutes.Supply power using six AAA batteries or the optional AC Adapter (AD 24ESA), and then press to turn on the power. Pressing the Preview key displays a preview of the label, and may differ from the actual label when printed. When selecting settings or lengths, press the Space key to return to the default value.Cursor key: Right (Use with the Shift key to go to end of the text.).Cursor key: Left (Use with the Shift key to go to top of the text.).Label length displayed on the LCD may differ slightly from the actual printed label length.The LCD displays one row of 15 characters however, the text you enter can be up to 80 characters in length.Label Length If a specific label length has been selected, also appears.Insert the Power Adapter into an earthed AC electrical socket.Insert the Power Adapter cord into the AC Adapter Socket on the side of the P-touch labeling system.If you prefer to use the optional AC Adapter (AD-24ESA) instead of using batteries: Close the Cassette Cover and gently press until it locks into place.

Use only Brother TZe or HGe tapes with this machine.Make sure your Tape Cassette is marked or.Gently press the Cassette into the P-touch labeling system until it locks into place. Insert the Tape Cassette following the drawing marked inside the case.This P-touch labeling system requires six AAA alkaline batteries or six fully-charged Ni-MH batteries, not included. When replacing batteries or tape cassettes, make sure the power is turned off.With the LCD facing down, open the Cassette Cover by pressing the grooved tab and pushing the cover in the direction of the arrow, as illustrated.7 Related Posts GETTING STARTED Installing Power Supply and Tape Cassette

Ptouch labeller